Author: Luchini, K.
Paper Title Page
MOPGF002 Magnet Corrector Power Supply Controller for LCLS-I 1
 
  • S. Babel, B. Lam, K. Luchini, J.J. Olsen, T. Straumann, E. Williams, C. Yee
    SLAC, Menlo Park, California, USA
 
  The MCOR-12[Magnet Corrector] is a 16-channel modular architecture, precision magnet driver, capable of providing bipolar output currents in the range from 12A to +12A. A single, unregulated bulk power supply provides the main DC power for the entire crate. Currently the MCORs have a 1000ppm regulation on the B-field. The MCOR controller card upgrades, existing LCLS-I and future LCLS-II needed, controls for Magnet Corrector Power Supplies. The project shifts the existing functionality of the VME based DAC and SAM and an Allen Bradley PLC into a new slot-0 card residing in the MCOR chassis. Elimination of the VME crate and the PLC will free up rack space to be used in future. The new interface card has a long term stability of 100 ppm and monitors ground fault currents and various other interlocks for the MCOR power supplies. The controller can interface to EPICS Channel Access and Fast Feedback system at SLAC using two Gigabit Ethernet ports and has an FPGA based EVR for getting 'time stamps' from the Event Generator system at SLAC. The EPICS control system along with embedded diagnostic features will allow for enhanced remote control and monitoring of the power supplies.
*S. Babel, S. Cohen, "Digital Control Interface for Bipolar Corrector Power, BiRa Systems, Albuquerque **G.E. Leyh, "A Multi-Channel Corrector Magnet Controller"
 
poster icon Poster MOPGF002 [1.646 MB]  
 
MOPGF015 Fast Wire Scanner Upgrade for LCLS 1
 
  • J.M. D'Ewart, M.L. Campell, P. Krejcik, H. Loos, K. Luchini
    SLAC, Menlo Park, California, USA
 
  Wire scanners are a main diagnostic tool for transverse beam size and emittance measurements at LCLS. The original SLAC wire scanners were not optimized for speed (taking minutes to scan), and can't perform at the desired level of position resolution necessary for measuring LCLS' small beam size. A new fast wire scanner, based on a dc linear servo motor, has been designed and installed in the LCLS. The new fast wire scanner has several advantages over the original wire scanner: scan times are reduced from minutes to seconds while minimizing wire vibrations. Rather than counting open-loop step pulses, the new fast wire scanner uses real time position capture for beam synchronous sampling of the wire position, enhancing beam profile accuracy.